1W-T-IB on-wall temperature sensor
A compact on-wall temperature sensor. Designed for indoor temperature measurements.
Note: The product has been discontinued. The sensor was replaced by the 1W-T-IB2.
Description
The 1W-T-IB sensor is designed for interior measurements of temperature and relative humidity in buildings. Its circuit board is placed within an on-wall box (P30 protection). The sensor can be also placed within a universal wiring box (KU68).
The sensor communicates with the master system using the 1-Wire bus (spring terminal, four conductors) and is fully compatible both with the Mervis IDE, an officially supported SW platform for Unipi products, and with the EVOK, an open-source application programming interface (API).
- Mervis: The sensor is based on the DS18B20 chip used in other 1-Wire thermometers on the Unipi e-shop and is used in the same way.
- EVOK: The sensor is detected automatically and can be used right away. Measured values are accessible on an address of the particular sensor also serving as a device identification. You can find the address on a sticker provided with the product.
The installation guide and technical parameters can be found in the product's datasheet (see the Files tab above).
Further info
Documentation
|
Product datasheet Datasheet of the product |
download |
| Temperature measuring range | -30 °C/+100 °C (+-1 °C accuracy) |
| Connection | 1-Wire (screw terminal) |
| Sensor type | DS18B20 |
| Power | 5 V (available on a connector along with 1-Wire) |
| Dimensions | 80 × 80 × 25 mm |
| IP rating | IP30 |
| Max. current draw | 1 mA |
| Installation | Wiring box (KU 68) |
